The DesignTek intake kit is a high quality moulded aluminum boxe that is powdercoated with a high temperature black texture. Using a CNC machined 6061 aluminum MAF housing, the air flow stays consistent and without any check engine lights using our air flattener mesh before the sensor. Connecting the two boxes together is a 3.5 inch diameter silicone tube. The air flows well with a K&N cone filter that comes pre-oiled and will last you almost 10,000 miles before you have to clean it. The filter is sealed in the left box to keep it cool from engine heat. As tested under normal road conditions, the air inside the box stays approximately 5-10F degrees cooler then the engine compartment air.
This intake has been proven to produce an impressive 32 wheel horsepower and 22 ft/lbs of torque in strong points of the RPM range. Peak numbers are 21 ft/lbs of torque and 7 wheel horsepower.
The Kit is available for the standard 996TT and the GT2 and can be used with the OEM decklid or the GT2 rear decklid, please choose your model
